Home > Knowledge > Content

Product Categories

Contact Information

  • Taizhou yuze mechanical and electrical co., ltd
  • Tel: +86-576-88178092
  • Fax: +86-576-88178091
  • Mob: +8613738584737
  • Add: Liuyang industry zone, Xiachen street, Jiaojiang district, Taizhou City, Zhejiang lirovince
  • EmailSales3@china-aircomliressors.com
Air pump use knowledge
Dec 24, 2018

The first is inspection and maintenance:

1. Always clean the air pump, such as dirt and dust, and clean it in time;

2. Regularly check the lubrication of the air pump to ensure that it has good lubrication performance;

3. Regularly clean the filter in the air pump, or replace it regularly. Under normal circumstances, the filter needs to be maintained for about fifteen days, and the screws and belts should be inspected regularly. Mainly to check the looseness of the situation, if it is found to be loose, it needs to be tightened in time;

4. For high temperature parts, regular inspections are also required;

5. The inspection of instruments and instruments in the air pump can not be less, mainly to check the accuracy of the instrument and the instrument, and the corresponding sensitivity;

6. Every year, relevant parts need to be regularly cleaned to ensure the normal use of the parts;

7. The replacement of the lubricating oil should also be regular. The initial use is replaced once every fifty hours, and then it is replaced once every three hundred hours.

Followed by the introduction of the air pump on the press:

When the air pump is pressurized, the normal test pressure is about 1.5 times the working pressure, so the small value cannot be lower than 0.6 MPa. The entire pressurization time can be determined according to the actual situation, and then after a certain pressure is lowered, the leakage and leakage are checked in detail, and if the inspection result is normal, the product will be qualified.